| [pdf] No Slide Title 40° to 140°F 5° to 60°C Injection Pressure 200 to 800 psi 1.4 to 5.5 MPa Pack and Hold Pressure 40 to 60 % 40 to 60 % Back Pressure 25 to 125 psi 0.2 to 0.9 MPa Screw...
| |
| [pdf] Formolene capacity Injection Speed: As fast as possible without causing cosmetic defects Pack / Hold Pressure: 50 - 75 % of injection pressure Hold Time: Until gate freeze achieved Screw...
| |
| [pdf] Base Resin Range... 165 o F ● Injection Pressure... As required ● Pack (Hold) Pressure... 65 - 75% of Inj. Psi ● Typical Drying Time 1 ... 4 hrs...
| |
| http://www.toshiba-machine.co...
Moldlyzer are: Injection process is divided into 4 segments: start, middle, pack, and hold. In all zones, the actual pressure is compared with the Model Curve and if it deviates...
| |
| [pdf] http://www.cpchem.com/enu/doc...
lot to lot differences. To ensure proper packing, the second stage pressure (Pack or Hold Pressure) should be the maximum possible. This is especially true since the amount of...
| |
| PSC Troubleshooting Parts too Small too slender. Make cores stronger to prevent misalignment by the injection pressure Overpacking problem. Reduce injection speed. Back off transfer point. Reduce pack/hold pressure....
| |
| Mastip - Support Solutions 1. Ensure adequate melt fill pressure. 2. Ensure consistent pack and hold pressures. 3. Reduce delay between pack and hold pressures. 4. Ensure screw non return...
| |
| |
| |
|
|
|